#Vox Tonelab St Patch List manual#

(From the hole of the lowercase, rotate the trimmer volume using a driver.) When only the green TUNER LED is lighting, the adjustment has completed. From the lower case, rotate the trimmer volume so that only the green TUNER LED is lighting. Wait till the tube becomes warm (1minutes). Input the sine signal of 1kHz +5dBm(1.378Vrms) to INPUT jack. Confirm that 1 is displayed in the 8 segments LED and other LEDs are turned off. Pressing the and the switch, turn the power on. Set the switch to the, set the AMP selector to the. TUBE SEND LEVEL ADJUST After changed tube, do following adjustment. Move the pedal without adding weight to the down position until the pedal stops.

Move the pedal adding weight (25kg) to the down position, move the pedal using hand to the up position until the pedal stops. EXP PEDAL CALIBRATION Pressing the and the switch, turn the power on. When the pedal is up position, 00 is not displayed in the 8 segments LED, When the pedal is down position, 7F is not displayed, and then you need do following calibration.

Step on and move the pedal, when the pedal is up 00 is displayed in the 8 segments LED, when the pedal is down position, 7F is displayed, this is OK. EXP PEDAL TEST Set the AMP/LINE switch to, pressing the and turn the power on.

#Vox Tonelab St Patch List manual#

1 VOX ToneLab ST SERVICE MANUAL TABLE OF CONTENTS ASSEMBLY SKETCH 2-3 BLOCK DIAGRAM 4 SCHEMATIC DIAGRAM: 5 TEST MODE: 6 PARTS LIST: 7-8 Issued: Mar.18, 2009 Ver VOX AMPLIFICATION LTD.ДҐ Tone Lab ST TEST MODE 1st Release Feb., murakita 1.